This is a drop in replacement for the stock paneldue mount that comes with Troodon v1. Reuse the screws to attach the mount
No supports needed
Printed with 20% infill
Reuse screws used for paneldue mount to attach new mount.
BOM:
4 x M3 heat inserts (6 if using the pi mount)
4 x M3x6mm screws (6 if using the pi mount)
Pi Mount
No supports needed
Printed with 20% infill
Reuse screws used for paneldue mount to attach new mount.
BOM:
4 x M3 heat inserts (6 if using the pi mount)
4 x M3x6mm screws (6 if using the pi mount)
Pi Mount
Last edited:
